36-inch jumper cable for LED Ruler, includes attached power connectors, black cord

Energy efficient, low profile task light installs easily and out of the way. Great for undercabinet, display, workspace, and many other task lighting applications. Dimmable with hardwire driver LED-DR18-350D (3-12 LEDs only). High light output with low energy consumption. Bright white 3100°K LED light with a sleek, ultra-slim design! Long life LEDs (up to 60,000 hours life). Durable and attractive brushed satin aluminum finish. Four conveniently sized units that can be interconnected to create custom lengths. LED Rulers interconnect end-to-end with inline connectors (included) and other accessories including jumper cables and 90° connectors. My LED Ruler will not light up. Why is it not working? Answer: If the LED Ruler is not lighting up when connected to a recommended 350mA driver, then fl ip the ?conkit? attached to the fi rst Ruler. This will not hurt the LEDs. It will simply change polarity (the direction of current). How do I wire LED Rulers around (or on both sides) of my stove? Do I need a long jumper? Answer: The best way to wire two separate areas of kitchen counters is to use two conkits attached to one driver (make sure you do not exceed the load capacity of the driver). When wiring two conkits to a driver, they do not connect in parallel. They connect in series so that one black wire and one red wire hook up to the driver. The other red and black wires connect to each other. How many LED Rulers can I run off of a single power supply? Answer: The maximum run for the LED Ruler is dependent upon the power supply used. If you use a 10 watt power supply, such as the LED-DR10-350AL, then you could create any combination of LED Rulers that do not exceed 8 LEDs total; i.e. two RULER-4?s, one RULER-5 and one RULER-3, etc. When you use the LED-DR12-350 or LED-DR18-350 hardwire drivers, do not exceed 9 or 14 LEDs, respectively. Each diode consumes 1.25 watts. Do not exceed the capacity of the 350mA driver. I need an enclosure for the driver. Is this available? Answer: Yes, use ENCL-11 for LED-DR18-350D. Standard 1/2? knockouts and lid are included. Can I dim the LED Ruler? Answer: Currently the LED Ruler can be dimmed using LED-DR18-350D dimmable, hardwire driver.